The Columns tab is available for SPC, DMS, Scripted SPC, and Scripted DMS retrievals.
On this tab, you can choose which columns of the raw data table (if any) to make available for the report.
Select the check box for each column you want to provide to the report, and clear the check box for each column that is not needed for the report.
For each data record that is retrieved for this report, GainSeeker will provide the selected columns to the report.
you choose Data (for an SPC retrieval),
and might have data with a subgroup size greater than eight, you should
change the settings for Dynamic Reports 2
to accommodate the larger subgroup size.
Similarly, if you choose Defects (for a DMS retrieval), and might have more than five defect reasons in a single data record, you should change the settings for Dynamic Reports 2 to accommodate the larger number of defect reasons.